TV stand for a 65-inch TV: what width, depth, height and weight rating you need

Most “TV stand for a 65-inch TV” advice stops at “get one that’s wider than the TV”. That ignores the two things that actually decide whether a stand works: how the TV itself stands (a pedestal in the middle or feet at the ends) and how high the screen ends up relative to your eyes. We worked both out from the manufacturers’ spec sheets for every current 65-inch model we track.

The numbers for each 65-inch TV

Enter your furniture’s width, depth and height in Will it fit? to see which TVs of every size fit it.

How the columns are worked out:

• Stand span is the width of the TV’s pedestal, or the outer distance across its two feet, from the spec sheet. Where a sheet doesn’t publish it, we leave it blank rather than guess; check the manual’s dimension drawing.
• Narrowest top that fits = span + 2 in each side, the bare minimum to keep feet away from the edge. It’s not a style recommendation.
• Stand height for eye-level center assumes a seated eye height of 40 in (typical for a sofa) and the TV on its own stand: stand height = 40 in − (the gap the TV’s stand adds under the screen + half the screen height).

Width: pedestal versus feet

The single biggest difference between 65-inch TVs on furniture:

• Center pedestal: LG C5 (18.5 in), Samsung S90F and S90H (14.4 in), Samsung QN90F (15.4 in), Hisense U8 and U7 (15.7 in) and Sony BRAVIA 9 II (13.5 in). Structurally, these fit on any top wider than about 18–23 in. Visually, a stand of 55–70 in looks right under a 57-inch-wide screen.
• Feet near the ends: Hisense U6 (44.6 in apart) and Sony BRAVIA 3 (46.4 in) need a top of at least 49–51 in. Sony’s BRAVIA 7 has a second, narrow foot position (18.9 in) for smaller furniture.

If you love a piece of furniture that’s too narrow for a TV’s feet, a universal tabletop pedestal stand that bolts to the TV’s VESA holes solves it; match its VESA range and weight rating to your TV (65-inch models use 300 × 200, 300 × 300, 400 × 300 or 400 × 400 mm).

Browse TV stands for 65-inch TVs on Amazon ↗

Depth: the overlooked number

A 65-inch TV on its own stand needs 9.1 in (LG C5) to 14.5 in (TCL QM7K and QM8K) of depth. Add the space for anything in front: soundbars are typically 3–5 in deep, and placing one in front of the TV’s stand can push the requirement to 16–20 in. Also leave a couple of inches behind the TV for cables.

Height: why lower is usually better

Many TV stands are 24–30 in tall. For a 65-inch screen, our table shows the ideal is about 21–23 in for a typical sofa. On a 30-inch stand, the screen’s center sits about 8 in above your eyes: watchable, but over a two-hour film your neck notices. If your seating is higher (bar stools, a high bed) or you sit very upright, add the difference.

Two quick checks:

1. Measure your eye height sitting where you watch: floor to eye level. Use it instead of our 40 in.
2. Center of screen = stand height + the TV stand’s lift + half the screen height (about 16 in for a 65-inch).

Weight and stability

Current 65-inch TVs weigh 36.6–59.7 lb without their stand (up to 67.5 lb with it). Add a soundbar (5–15 lb), a console and a receiver, and a stand rated for 100 lb or more gives sensible headroom.

Anchor the TV and the stand to the wall. The U.S. Consumer Product Safety Commission’s Anchor It! campaign recommends anchoring both TVs and furniture; most TVs have threaded holes on the back (the VESA holes) for an anti-tip strap, and many stands include a wall strap.

Why it matters. The CPSC’s 2023 tip-over report estimates about 17,800 emergency-room-treated injuries a year (2020–22 average) from furniture, TVs and appliances tipping over, and 217 deaths reported from January 2013 to July 2023, most of them children. TVs must pass a stability test to be sold (UL safety standards), but no anti-tip strap has to come in the box, so buy one: most TVs accept a strap in their VESA holes.

Checklist before you buy

• Top width ≥ the TV’s pedestal or feet span + 4 in (see the table), and wide enough to look balanced
• Top depth ≥ the TV’s stand depth + soundbar depth + 2 in for cables
• Height puts the screen’s center near your seated eye level
• Weight rating covers the TV on its stand plus all the equipment
• Ventilation for consoles and receivers in closed cabinets
• Anti-tip straps for the TV and the stand

Want it on the wall instead? Mount height and hardware are covered in mounting a TV on metal studs; dimensions of every model are in 65-inch TV dimensions.